SM2502
61
MAIN FUNCTIONS OF THE WASHING MACHINE
C Optional function buttons
G On/Off button
H Timer knob
L Start button
P Programme and temperature knob
S Programme status led
GB
USING THE APPLIANCE
CICLO DI LAVAGGIO:
“EASY LOGIC” TECHNOLOGY
The electronic washing machine is fi tted with an “EASY LOGIC” system that automatically
recognises the quantity of washing loaded. The machine can thus regulate the amount of
water to use for the wash and proportion the wash time accordingly, thus saving water,
time and energy. In the case where the amount of washing is less than the maximum
recommended load (see technical characteristics table), the quantity of water used for
the wash will be reduced by 2 litres for each kg less of washing. In the case of a half-load
or less, the machine will automatically carry out one rinse less than programmed.
N.B. The “EASY LOGIC” function is only active for cotton programmes.
WASHING MACHINE OPERATION:
(follow these instructions and the washing machine will run the selected
wash cycle)
Load the washing machine, add the detergent and softener (see “Detergent drawer”)
using the manufacturer’s recommended doses reported on the packet. Check that
the machine is plugged into the mains socket, that the door is closed, the water feed
valve is open and that the ON/OFF button is pressed.
Rotate the programmer knob to select the required program and temperature
according to the type of fabric to wash (see program table).
Rotate the timer knob to set the required drying time.
When setting the drying time, the “drying” led will stay lit until the “Start” button is
pressed, at which time it switches off and the machine starts the wash cycle.
The fi gure alongside shows the main functions of a wash cycle:
WASH, RINSES, SPIN, END.
During the cycle, each of these functions is highlighted by a led informing the
user what the washing machine is doing at that moment. After the spin phase, the
corresponding led will stay lit for approximately 2 minutes; this is the time lapse
necessary before the door can be opened. At this point the “END” led will light up.
The DRY function led lights up while the drying time is being set and fl ashes during
the fi nal ten minutes (cooling) of the drying phase.
To Next Page
Loading...