© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Operation
70283601
12
Figure 3
Manual Timer
1. Set the HEAT/DRYING timer for the number of
minutes (from 0-60) desired.
2. Set the COOL DOWN/COOLING timer for the
number of minutes (from 0-15) desired.
3. Set the TEMPERATURE selector at HIGH,
MEDIUM, LOW or anywhere between these
settings.
4. Press the PUSH TO START button in and hold it
in for approximately three seconds. This starts
the tumbler cycle.
IMPORTANT: If the loading door or lint panel
door is opened during the cycle, the heating system
will shut off and the motor will stop. To restart the
cycle, door must be closed and the PUSH TO
START button must be pressed in.
5. When the cycle is complete, open door and
remove the laundry.
TMB804N
REVERSING MODELS
To Next Page
Loading...
