Table of Contents
v
CHAPTER 7 - PRINTEK EMULATION 7-1
Introduction 7-1
Control Codes and Escape Sequences 7-3
Communications 7-3
Character Size 7-4
Character Attributes 7-5
Character Sets 7-6
Line Pitch 7-7
Horizontal Position 7-8
Vertical Position 7-8
Form Length and Form Feed 7-9
Horizontal Tabs 7-10
Vertical Tabs 7-11
Horizontal and Vertical Tabs 7-12
Horizontal Margins 7-12
Vertical Margins 7-13
Graphics 7-14
Printer Controls 7-17
Forms and Tractors 7-19
Emulations 7-20
Control Codes and Escape Sequences (Alphabetical) 7-21
CHAPTER 8 - HEX DUMP MODE 8-1
APPENDIX A - OPTIONAL COAXIAL/TWINAXIAL INTERFACE 1
Introduction A-1
Automatic Port Switching A-1
Command Interpreter A-2
APPENDIX B – Printing Basic BAR CODEs B-1
Introduction B-1
Bar Code Sequences B-4
Measurements in Bar Code Mode B-4
Entering/Exiting Bar Code Mode B-5
The Bar Code Control Character B-5
Other Control Characters B-5
Bar Code Definition B-6
Bar Code Height B-9
Relative Vertical Tab B-10
Absolute Horizontal Tab B-10
Bar Code Pass Terminator B-11
Mixing Bar Codes and Text B-12
Supported Bar Code Types B-13
APPENDIX C - ASCII CHARACTER TABLES C-1
ASCII Control Code Definitions C-1
Decimal to Octal to Hexadecimal Conversion Table C-7
APPENDIX D - PRINTER RESET CONDITIONS D-1
GLOSSARY Glossary- 1
To Next Page
Loading...
