Pro-4 Tactical Secure Touch Lock - Deleting Fingerprints; Fingerprint Deletion Process; TSA Lock Access; TSA Manual Mode

MAINTENANCE
• Clean Secure Touch Lock with a clean, dry cloth as needed
• Lubricate moving parts with standard consumer lubricant as needed
• Please only use the included USB-C charge cable to charge lock. Recommended charger output: DC5V 450mA
Light will display GREEN while charging, and will turn o when complete
• Stop using lock if it starts smoking, is overheated, discolored, or deformed
• Do not use the lock in a violent manner
• If lock is left unused for a period of time, battery will drain and must be recharged
• Do not use if lock is thoroughly wet; electric shock can occur
• Children must use this lock with parental guidance. Recommended for Ages 14+
• If your padlock starts acting abnormally, try resetting: use any registered ngerprint (user or administrator) on the sensor,
then press the setting button after the red light turns o
• See www.Pro-4Tactical.com for Warranty and Replacement Information
CALIFORNIA PROP 65 WARNING: This product can expose you to chemicals including Benzene and Ethylbenzene which are known
to the State of California to cause cancer. For more information, go to www.p65Warnings.ca.gov
WARNING
TROUBLESHOOTING
DELETING FINGERPRINTS
To delete ngerprints from memory or to set a new Administrator ngerprint, the lock must rst be reset.
1. Press the ngerprint pad until the
light ashes RED. It is now ready
to identify the active administrator
ngerprint.
• T he RED light will ash for 5
seconds. If there is no activity, the
lock will go into standby mode.
2. Press the administrator
ngerprint on to the
ngerprint pad.
Lock shackle
LED instruction
lights
Fingerprint
sensor
TSA007 lock
cylinder
micro-USB
Charging interface
setting button
1.Registered fingerprint
2.Press the setting button after the red light is out.
Lock shackle
LED instruction
lights
Fingerprint
sensor
TSA007 lock
cylinder
micro-USB
Charging interface
setting button
1.Registered fingerprint
2.Press the setting button after the red light is out.
If the lock has been
successfully reset, the
light will display RED
followed by a long beep,
then go into standby mode.
If the lock has not been
successfully reset, the
light will ash RED
followed by 4 beeps, then
go into standby mode.
TSA LOCK ACCESS
Every TSA-approved lock has a manual mode, which can only be used by the
Transportation Security Administration (TSA). The manual access mode is provided
so the TSA can access locked items, if necessary.
Only TSA employees are authorized to access the manual mode of the Secure
Touch Lock.