Pro Boat Rockstar 48 PRB09000

Questions and Answers

B
Benjamin TaylorAug 20, 2025
What to do if Pro Boat Rockstar 48 PRB09000 Toy engine starts then stalls?
- R
  ruizjamesAug 20, 2025
  If your Pro Boat Toy engine starts and then stalls, consider these possibilities: You might be out of fuel, so refill the tank and follow the starting instructions. The engine could be overheated; let it cool, reset the carburetor to factory settings, and restart. The engine idle might be too low, so follow the instructions to increase the idle speed. The carburetor might be incorrectly adjusted; return it to the factory settings and retune if necessary. The clutch could be slipping or locked-up; repair or replace it. The fuel mixture could be old or bad; mix fresh fuel per instructions. The throttle servo might be improperly set up; set the servo to neutral and reset the linkage. Finally, the clutch or flex shaft might be unable to turn; repair or replace any damaged parts.
K
Kathy VelasquezAug 22, 2025
Why Pro Boat Rockstar 48 PRB09000 will not connect?
- A
  Adam GravesAug 22, 2025
  If your Pro Boat Toy will not connect, it might be because the transmitter is too close to the boat during the connecting process. Move the powered transmitter a few feet away from the boat, then disconnect and reconnect the battery to the boat. Another cause may be a large metal object or wireless source near the boat or another transmitter. Move the boat and transmitter to another location and try connecting again. Also, check if the receiver or transmitter battery charge is too low, and replace or recharge the batteries. Finally, make sure the receiver switch is powered on.
S
Shawn KnappAug 25, 2025
What to do if Pro Boat Toy will not bind?
- S
  sarah72Aug 26, 2025
  If your Pro Boat Toy will not bind, the transmitter might be too close to the boat during the binding process. Move the powered transmitter a few feet away from the boat and disconnect and reconnect the battery to the boat. A large metal object or wireless source could also interfere; move the boat and transmitter to another location and attempt binding again. Ensure the receiver and transmitter batteries are adequately charged by replacing or recharging them. Also, check that the receiver switch is powered on.
B
barnettericaAug 27, 2025
What to do if the rudder does not move on Pro Boat Rockstar 48 PRB09000?
- S
  Stacie RodgersAug 28, 2025
  If the rudder on your Pro Boat Toy does not move, there might be damage to the rudder, linkage, or servo. Replace or repair any damaged parts and adjust the controls. Also, check the servo wire for damage or loose connections, connecting or replacing parts as needed. Ensure the transmitter is correctly bound by re-binding the receiver to the transmitter. Finally, verify that the receiver switch is powered on.
R
Richard MartinezAug 30, 2025
Why Pro Boat Rockstar 48 PRB09000 tends to dive in the water?
- W
  William CantuAug 30, 2025
  If your Pro Boat Toy tends to dive in the water or takes on water, it could be due to the boat hull not being completely closed. Dry out the boat and ensure the hatch is fully closed on the hull before returning the boat to the water. Another possible cause is an incorrect prop angle, which needs adjustment.
A
Amanda BerrySep 1, 2025
How to fix extra noise or extra vibration in Pro Boat Rockstar 48 PRB09000 Toy?
- B
  Brittany CameronSep 1, 2025
  If your Pro Boat Toy exhibits extra noise or vibration, it could be due to a damaged propeller, shaft, or engine, in which case you should replace the damaged parts. Another possibility is that the propeller is out of balance, so balance or replace the propeller.
D
Donald RothSep 4, 2025
What causes low receiver battery charge in Pro Boat Rockstar 48 PRB09000?
- T
  thompsonmicheleSep 4, 2025
  If your Pro Boat Toy receiver battery charge is low, the receiver battery may be damaged, so replace the battery and follow the battery instructions. Make sure to completely recharge the battery. Check for blocking or friction on the shaft or propeller; disassemble, lubricate, and correctly align the parts. Ensure the battery is warm before use, as cold boat conditions may affect it. The battery capacity might be too low, so replace it with a larger capacity battery if the boat is underpowered for the conditions. Ensure the drive dog is not too close to the prop strut; loosen the drive dog and move it away a small amount. Fully lubricate the flex shaft if there is too little lubrication. Remove any vegetation or obstacles blocking the rudder or propeller.
A
Alejandra GarrettSep 6, 2025
Why Pro Boat Rockstar 48 PRB09000 Toy tends to turn one direction?
- W
  William AlvarezSep 7, 2025
  If your Pro Boat Toy tends to turn in one direction, the rudder or rudder trim might not be centered. Repair the rudder or adjust the rudder and rudder trim for straight running when the control is at neutral.
M
Michael ByrdSep 9, 2025
How to fix reversed controls on Pro Boat Rockstar 48 PRB09000?
- W
  Willie BurgessSep 9, 2025
  If the controls on your Pro Boat Toy are reversed, the transmitter settings might be reversed. Perform the Control Direction Test and adjust the controls on the transmitter appropriately.
D
Dale WatsonSep 12, 2025
What to do if Pro Boat Toy will not respond to throttle?
- J
  Jeremiah SteinSep 12, 2025
  If your Pro Boat Toy will not respond to the throttle but responds to other controls, the throttle channel may be reversed. Reverse the throttle channel on the transmitter.

Summary

Meaning of Special Language

Safety Precautions and Warnings

Introduction to Pro Boat

Recommended Tools and Materials

Product Inspection Guide

Specifications Overview

Boat Stand Assembly

Canopy Removal Procedure

Propeller Installation

Rudder Installation

Charging the Receiver Battery

Receiver Battery Installation

Antenna Tube Installation

Spektrum DX2 E Radio System

Transmitter Controls and Functions

Overview of key controls like steering, throttle, trim, and dual rate.

Transmitter Indicators and Antenna

Explains indicator lights, ON/OFF switch, and antenna.

Installing Transmitter Batteries

Step-by-step guide for inserting AA batteries into the transmitter.

Radio System Binding Process

Failsafe Functionality

Radio Range Check Procedure

Fuel Safety and Usage Instructions

Fuel Mixing Precautions

Fueling the Boat

Vehicle Starting and Running

Breaking in the Engine

Boating Tips and Advice

Stopping the Engine

Procedure When You Are Finished

After Boating Maintenance

Steering Trim Adjustment

Throttle Trim Adjustment

Engine Tuning

Carburetor Factory Settings

Baseline settings for the engine carburetor to optimize performance.

Adjusting the High Speed Needle

Procedure to adjust the high-speed needle for optimal engine performance.

Adjusting the Low Speed Needle

Procedure to adjust the low-speed needle for vehicle acceleration.

Idle Speed Adjustment

How to adjust the engine's idle speed for proper operation.

Spark Plug Test Procedure

Flooded Engine Troubleshooting

General Maintenance Checks

Engine and Mount Inspection

Inspect engine and mounts for damage, wear, and clean/repair as needed.

Spark Plug and Wire Inspection

Inspect spark plug and wire condition, replace if necessary.

Muffler and Carburetor Checks

Inspect tuned muffler for damage/leaks and check carburetor for leakage.

Clutch Operation and Maintenance

Water Cooling System Maintenance

Prop Angle Adjustment

Drivetrain Lubrication Guide

Troubleshooting Guide

Engine Troubleshooting Guide

Limited Warranty Information

What this Warranty Covers

Details the warranty coverage for product defects in materials and workmanship.

What is Not Covered

Exclusions from warranty, including cosmetic damage and misuse.

Purchasers Remedy

Explains the sole remedy available to the purchaser for defective products.

Limitation of Liability

Defines Horizon's liability limits for special, indirect, or consequential damages.

Legal Terms and Governing Law

Specifies governing law and legal rights related to the warranty.

Warranty Services and Support

Questions, Assistance, and Services

Guidance on obtaining product support and assistance from Horizon.

Inspection or Services Process

Instructions for submitting product for inspection or service.

Warranty Requirements

Mandatory requirements for warranty consideration, including proof of purchase.

Non-Warranty Service Policy

Warranty and Service Contact Information

FCC Information Compliance

IC Information Compliance

European Union Compliance

Declaration of Conformity

Statement of product conformity with European specifications.

Disposal of WEEE Instructions

Guidance for users on proper disposal of waste electrical and electronic equipment.

Replacement Parts List

Optional Parts List

Pro Boat Rockstar 48 PRB09000 Specifications

General

Motor Size/Type	Brushless
Speed	50+ mph
Hull Material	Fiberglass
Drive System	Flex Shaft
Scale	1/8
Hull Type	Deep-V
Recommended Environment	Freshwater
Charger	Not included
Type	Electric
Length	48 in
Battery	LiPo 6S
Speed Control	120A ESC
Radio	2.4GHz
Propeller	3 Blade