pro comp K2079BMX - Page 12

12
56713B/K2079B
Revised
2.19.15
43. Torque the control arms to specifications
chart in the rear of the instructions.
44. Drill out the existing track bar mounting
hole in the frame to 5/8”.
45. Secure the track bar drop bracket (91-
7658) to the frame mounting pocket by
inserting the 5/8” X 4 1/2” bolt, from the
backside, 5/8” hardware and (90-8231
long sleeve, in between the OE frame
mounting pocket and the 90-8232
short sleeve, in front of the OE frame
mounting pocket and the backside of
the track bar drop bracket 91-7658).
See ILLUSTRATION 9.
NOTE: Be sure to use thread locker
on this bolt. DO NOT the bolt torque
at this time.
46. Insert the 7/16” X .788” split sleeve
(61734) into the crossmember hole clos-
est to the driver side track bar mount.
OE Frame
Mounting
Pocket
5/8” X 4
1/2” Bolt
OE Track Bar
91-7658
Track Bar
Drop Bracket
90-4460
Track Bar
Nut
OE Crossmember
Cam
Hardware
1/2” X 2
1/2” Bolt
7/16” X 3” Bolt
90-8232
Shorter
Sleeve
90-8231
Longer
Sleeve
61734 7/16”
Split Sleeve
90-8233
X-member
Sleeve
90-7882
7/16”
Washer
90-7882 7/16” Washer
ILLUSTRATION 9
5/8”
Hardware
7/16” Nut
OE Track Bar
90-4412
Cam Bolt
90-8232
Shorter
Sleeve
90-8231
Longer
Sleeve
5/8” X
4 1/2”
Bolt
91-7658
Track Bar
Drop
Bracket
Track Bar Drop Bracket
Side View
Front of Vehicle