Need help?Do you have a question about the Pro-Ject Audio Systems Tube Box DS2 and is the answer not in the manual?
General| Type | Phono Preamplifier |
|---|---|
| Outputs | 1 x RCA |
| Tube complement | 2 x ECC83 (12AX7) |
| Inputs | 1 x RCA |
| Frequency Response | 20Hz - 20kHz |
| Power Supply | 15 V DC |
| Input Impedance | 47 kΩ |
| Noise Floor | -80 dB |
| Signal-to-Noise Ratio | 80 dB |
Follow safety instructions, avoid wet conditions, keep flames away, and ensure correct power supply usage.
Connect tonearm signal leads to IN1/IN2. Connect earthing wire for hum issues.
Connect outputs to amplifier line inputs. Connect power supply plug before mains.
Utilize trigger input/output sockets (2.5mm, 12V) for remote power control of connected units.
The front panel switch turns the unit on or to standby. A blue LED indicates power status.
Adjust input/output, subsonic filter, and gain settings. Changes store automatically.
Set input impedance for low-output MC (variable 100-10000 ohm) or high-output MC/MM (47k ohm).
Select input capacitance for high-output MC and MM cartridges (100pF, 220pF, 320pF).
Provides recommended settings for common Ortofon MM and MC cartridges.
Details include tubes, impedance, capacitance, gain, output, noise floor, THD, and dimensions.
Diagnose issues like no signal, hum, or distorted output related to connections or gain.
Contact dealer for unresolved issues. Manufacturer not liable for unauthorized modifications.
Information copyright Pro-Ject Audio Systems © 2016. Manufacturer reserves right to change specs.
To Next Page
