Need help?Do you have a question about the Pro-Ject Audio Systems Phono Box RS and is the answer not in the manual?
General| Type | Phono Preamplifier |
|---|---|
| Gain MM | 40 dB |
| Gain MC | 60 dB |
| Input | RCA |
| Input Impedance | 47k Ohm |
| Input Capacitance | 100 pF (MM) |
| Frequency Response | 20 Hz - 20 kHz |
| THD | < 0.01% |
| Signal to noise ratio | 80dB (MM) |
| Output | RCA |
Explains how to switch the unit on or back into standby mode using the front panel switch.
Details the ON/MUTE function for activating and deactivating audio muting.
Guides on selecting the desired de-emphasis curve between RIAA and DECCA.
Instructions for setting input gain, capacitance, and impedance using switches and rotary controls.
Details selecting RCA/XLR connectors and setting input gain levels for each.
Explains setting variable input impedance for low-output MC cartridges using the rotary control.
Guides on setting variable input capacitance for MC and MM cartridges using dip switches.
Details setting fixed input impedance for low-output MC cartridges via dip switches.
Describes the RCA/XLR input/output connectors and how to select them.
Explains how to activate and deactivate the subsonic filter.
Provides instructions for connecting the record player and the amplifier.
Details the procedure for connecting the mains power supply to the unit.
Lists key technical specifications including impedance, capacitance, gain, noise floor, and dimensions.
Addresses potential problems like no signal, hum, or distorted output and their likely causes.
Provides guidance on contacting a dealer for service if issues persist.
Outlines the manufacturer's warranty terms and conditions.
To Next Page
