pro.point 18 GAUGE AIR BRAD NAILER User Manual (English)

Questions and Answers:

L
Laura BeckerAug 8, 2025
Why pro.point 18 GAUGE AIR BRAD NAILER won't drive fasteners or operates sluggishly?
- T
  tinabaxterAug 8, 2025
  If your pro.point Tools won't drive fasteners or operates sluggishly, it could be due to several reasons: * Inadequate air supply: Verify that the air supply is sufficient. * Inadequate lubrication: Place 2 to 4 drops of oil into the air inlet. * Worn or damaged O-rings or seals: Check and replace them as needed. * Blocked exhaust port: The exhaust port in the cylinder head may be blocked, consider replacing damaged internal parts.
C
Christopher SalasAug 12, 2025
How to fix pro.point 18 GAUGE AIR BRAD NAILER Tools when it jams?
- A
  Andrea DavidsonAug 12, 2025
  If your pro.point Tools is jamming, consider the following: * Incorrect or damaged fasteners: Change to the correct type of fastener. * Damaged or worn driver guide: Check and replace the driver if necessary. * Loose magazine or nose screw: Tighten the magazine. * Dirty magazine: Clean the magazine.
M
Michael CareyAug 17, 2025
What to do if pro.point 18 GAUGE AIR BRAD NAILER misfires?
- R
  Rebecca BrownAug 17, 2025
  If your pro.point Tools is misfiring, the issue could be due to: * Worn bumper or damaged spring: Replace the bumper or pusher spring. * Dirt in front plate: Clean the drive channel on the front plate. * Dirty magazine: The magazine needs to be cleaned. * Worn or dry O-ring on piston: Replace and lubricate the O-ring. * Leaking cylinder cover seal: Replace the sealing washer.
T
Todd ParkerAug 21, 2025
How to prevent pro.point Tools blade from driving fastener too deep?
- P
  patrick58Aug 21, 2025
  If the blade of your pro.point Tools is driving fasteners too deep, it could be due to: * A worn bumper: Replace the bumper. * Air pressure is too high: Adjust the air pressure.
K
Kevin NguyenAug 25, 2025
What causes air leak near bottom of pro.point 18 GAUGE AIR BRAD NAILER Tools?
- D
  David WeaverAug 26, 2025
  An air leak near the bottom of your pro.point Tools could be caused by: * Loose screws: Tighten the screws. * Worn or damaged O-rings or bumper: Check and replace the O-rings or bumper.
P
Patrick GrayAug 29, 2025
How to troubleshoot air leak near top of pro.point 18 GAUGE AIR BRAD NAILER or in trigger area?
- S
  Stephanie StephensonAug 29, 2025
  If you notice an air leak near the top of your pro.point Tools or in the trigger area, the cause may be: * Damaged O-ring in trigger valve: Check and replace the O-ring. * Damaged trigger valve head: Check and replace the trigger valve head. * Damaged trigger valve stem, seal, or O-ring: Check and replace the trigger valve stem, seal, or O-ring.
T
Tanner NortonSep 3, 2025
Why is there an air leak between body and cylinder cap of pro.point Tools?
- M
  Michael FloresSep 3, 2025
  An air leak between the body and cylinder cap of your pro.point Tools may be due to: * Loose screws: Tighten the screws. * Worn or damaged O-rings or seals: Check and replace the O-rings or seals.