Need help?Do you have a question about the pro.point 8424400 and is the answer not in the manual?
Specifies whether the tool measures in SAE or Metric units.
Defines the maximum and minimum distances the tool can measure.
Lists various scenarios and professions where the tool is useful.
Details the product's design, usability, and included accessories.
The main screen for displaying measurements and status information.
Buttons used to operate the device functions and settings.
The grip for holding and maneuvering the surveyor's wheel.
The telescopic shaft for adjusting the height of the handle.
A strap or mechanism for securing the wrist to prevent drops.
The casing that encloses and protects the measuring wheel.
The calibrated wheel that measures distance as it rotates.
A support to keep the wheel upright when not in use.
Button to turn the device on and off.
Button to switch between metric and SAE units.
Button for resetting measurements or navigating memory to the right.
Button for backlight and navigating memory to the left.
Button to enter memory mode and save readings.
Button to hold current measurement or release it.
Indicates the unit of measurement (meters/feet).
Indicates the unit of measurement (cm/inches).
Alerts the user when the battery is low.
Indicates that the current measurement is being held.
Indicates active memory slots.
Turn the tool On by pressing the On/Off button and holding the button for two seconds.
Press the M/Ft button to switch the unit of measurement from Metric to SAE.
Press and hold the Reset button for two seconds to set the number to zero.
Measure distance between two parallel walls by rolling the wheel.
Measure distance from a wall to a specific point.
To Next Page
General
