PRO SHOT L1-AS - Safety

4
Safety
Precautions to follow when using any laser.
• Don't stare into the laser beam or view it directly with optical instruments.
• Don't disassemble the laser or attempt to service it.
• Don't use the laser until you have read the instruction manual and you are
familiar with how to operate the laser properly.
U.S. OSHA requirements for operating visible lasers.
• Only qualied, trained employees may install, adjust and operate the laser.
• Laser operators must carry proof of qualication.
• The area of a job site where a laser is being used must be posted with a laser
warning placard.
• The laser should be set up above eye level and never intentionally aimed at
anyone.
• Turn the laser o when it is not being used, such as during lunch hour, at the end
of the day, or during other long breaks in the work.
L1-AS
(IEC)
LASER LIGHT
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
A warning placard is included with each
laser which can be attached to the outside
of the carrying case. The case can then be
placed in a visible location near where the
laser is being used in order to meet jobsite
posting requirements.
L1-AS
(North America)
CAUTION
CAUTION
LASER LIGHT
DO NOT STARE
INTO BEAM
635nm - 670nm
CLASS II LASER PRODUCT