INTELLIGENT BATTERY CHARGER
A series of chargers that are protected against
damage with watertight ABS housings
12-bit AD microprocessor with 4-stage charging characteristic for
use in small automobiles and motorcycles
For common lead and gel batteries
TÜV-/GS-tested
CE-tested
DFC 530 intelligent battery charger with 5.3 A RMS
– Charges with 6 or 12 V, 3.5 A DC (5.3 A RMS)
– For gel cell or common lead acid batteries
– Self-identifying four-stage characteristic curve, full capacity,
absorption, floating operation
– Watertight housing, Ingress Protection Rating IP 65
– Dimensions: (LxWxH) 16x7x4cm
Features:
– Full protection against sparks
– Short circuit protection
– Voltage compensation
– Temperature compensation (5-6 temperature settings)
– Overheating protection
– Polarity reversal protection
Indicators:
– Reversed polarity – reversed connection
– Battery < 3V – battery fault
– Connection to power supply – when the charger is connected
too a source of alternating current.
– Charging – when the battery is absorbing the charge
– Battery charged – when the battery is completely charged or
in floating operation mode
To Next Page
