PROGRAMMING THE THERMOSTAT
7
Temporary and Permanent Hold Feature
Temporary hold: The thermostat will display HOLD
and RUN SCHEDULE on the bottom of your screen
when you press the or key. If you do nothing,
the temperature will remain at this setpoint for four
hours. Your program setpoint will then replace your
temporary setpoint.
Permanent hold: If you press HOLD key at the bottom
of your screen, you will see HOLD appear below the
setpoint temperature in the display. The thermostat will
now permanently stay at this setpoint and can be
adjusted using the or keys.
To return to program: Press the RUN SCHEDULE key
at the bottom of your screen to exit either temporary or
permanent hold.
Filter Change Reminder
If your installing contractor has
configured the thermostat to remind you
when the air filter needs changed, you will
see FILT in the display when your air filter
needs changed. FILT will be shown in the
display after your system has run long
enough to require an air filter change.
Resetting the filter change reminder: When
FILT reminder is displayed, you should
change your air filter and reset the reminder
by pressing the CLEAN key for 3 seconds.
FILT will leave the display when reset.
Next Zone (Only if R251W is connected)
The NEXT ZONE key cycles through all
sensors connected to your wireless system.
SYSTEM AVERAGE shows the average
ambient temperature of all connected sensors.
LOCAL shows the ambient temperature of
the T955W only.
The name of the R251W remote sensors will
show and the ambient temperature for that
sensor only will be displayed.
For more information,
see the R251W User Guide.
Hold down CLEAN for 3 seconds,
to reset filter reminder.
To Next Page
Loading...
