PROAIM BMP-40R - Blimp Mic Windshield Setup; Cage Opening and Component Removal; Microphone Installation and Cage Reattachment

2
 Open the locking clip on the blimp cage from
both sides as shown in the image.
 Take the mic holder rod out of the cage.
NOTE: The rubber and holder clamps come
aached to the rod. But if any rubber or clamp
is not in a good condion, you can replace it as
shown in the images.
Blimp Mic Windshield Setup
 Insert mic into the suspension system and
connect it with a connector cables.
 Remove the cap on the blimp cage as shown
in the picture.
 Then, slide on the blimp cage to aach it back
to the handle.