How to fix reversed controls on ProBoat Veles 29 Toy?
If your ProBoat Toy boat controls are reversed, it indicates that the transmitter settings are reversed. Perform the Control Direction Test and adjust the controls on the transmitter accordingly.
How to fix no steering on ProBoat Veles 29?
If you are experiencing no steering or a lack of steering with your ProBoat Toy boat, it could be due to the steering rate not being adjusted correctly. Adjust the steering rate (ST RATE) knob on the transmitter to achieve the desired steering throw.
Provides essential safety guidelines for responsible operation and handling.
Critical safety warning about using identical batteries when connecting in series.
Explains LVC function, storage issues, and damage from repeated use.
Explains how the failsafe feature works and when it activates during signal loss.
Steps to ensure controls function correctly and a critical warning about water cooling.
Guide for placing the boat in water, slow speed operation, and checking coolant flow.
How to adjust steering trim and mechanically center the rudder.
Steps for powering down, cooling components, and the correct power-off sequence.
Detailed steps for draining, drying the hull, and removing the hatch.
Instructions for lubricating the flex shaft and performing minor repairs.
Checks and procedures if water does not exit the outlets.
Detailed steps for lubricating the flex shaft and advice for saltwater use.
Solutions for no throttle, noise, vibration, reduced runtime, and pulsing power.
Solutions for binding failures, connection errors, diving, water intake, and steering problems.
Troubleshooting motor overheating, ESC tones, lack of throttle, and boat moving unexpectedly.
To Next Page
General