ProBreeze PB-06 - Page 10

10 of 92 | English
Setting a Turn-Off timer:
1. Press the Power button to turn the dehumidier on.
2. Set the dehumidier to the desired settings.
3. Press the Timer button to activate the timer function.
4. Press Timer button to set the desired time (1-24 hours).
5. The time digits will blink ve times to conrm a timer has been set and then revert to the
current room humidity.
6. To check the remaining time until Time-Off press the Timer button.
SLEEP Mode: Press the SLEEP mode / STORAGE Cycle Button to activate. In SLEEP mode the
dehumidiers humidity is set to 50% and the fan operates in low speed. If the actual room
humidity is 5% greater than 50% humidity the dehumidiers compressor will activate, and the
fan will operate at low speed. If the actual room humidity is 5% less than 50% humidity the
dehumidiers compressor will stop collecting water but the fan will continue to operate at low
speed.
Note: Fan speed cannot be adjusted when SLEEP mode is set.
STORAGE Cycle: Press and hold the SLEEP mode / STORAGE Cycle button for three seconds to
activate. The dehumidiers compressor stops collecting water, and the fan runs at high speed
for 30 minutes followed by a further 20 minutes at low speed. This process dries the dehumidier
prior to storage.
Note: Prior to storage ALWAYS run a STORAGE cycle.
Fan Speed Button: Sets the fan speed to HIGH or LOW speed.
Humidity Button: Sets your desired humidity level between 80% - 30% humidity in 5%
decrements.
Mode / Child Lock Button: Select between AUTO mode / CONTINUOUS mode / Child Lock.
AUTO Mode: In AUTO mode if the actual room humidity is 5% greater than that of the set humidity
the dehumidiers compressor will activate, and the fan will operate at the set fan speed. If the
actual room humidity is 5% less than that of the set humidity the dehumidiers compressor will
stop collecting water, but the fan will continue to operate at the set fan speed.
CONTINUOUS Mode: In CONTINUOUS mode the dehumidiers compressor and fan (at the set fan
speed) will continuously operate. In this mode the fan speed is adjustable.
Child Lock: Locks the controls for child safety. Press and hold the Child Lock button for three
seconds to lock and unlock. The display panel will show LC for ve seconds after Child Lock is
activated prior to returning to the current room humidity.
Power Button: Turns the dehumidier ON and OFF.