7 | English
ERROR CODES
―
ERROR CODE CAUSE SOLUTION
E0
The wiring has
malfunctioned.
Contact Pro Breeze Customer Care by
sending an email to help@probreeze.com
or via our website www.probreeze.com
E2
The humidity sensor is
unable to detect the humidity
of the environment.
LO
The humidity of the
environment is below 20%
The appliance will automatically shut
down to prevent damage. Move the
appliance to a more suitable environment
and manually restart it.
HI
The humidity of the
environment is above 90%
CL
The temperature of the
environment is below 5℃
CH
The temperature of the
environment is above 38℃
CONTINUOUS DRAINING
―
To connect the drain hose to the unit:
1. Insert one end of the hose into the
continuous drainage hole of the unit.
Ensure it is connected securely.
2. Place the other end of the hose into a
bucket or a drain.
3. Ensure the hose is not bent or blocked.
Note: Gravity will pull the water out of the
unit into your chosen drainage area. Ensure
the chosen area is not higher than the unit.
MAINTENANCE
―
Removing the water tank:
• When the water tank is full, the unit will
make a buzzing sound, and the Water
Full light will turn on.
• Press the power button to turn o the
unit.
• Slide the water tank out of the body of
the dehumidier.
• Empty the water tank and clean the
inside and the outside.
• Replace the empty tank back into the
unit.
• Press the power button to resume
operating.
• If the Water Full light does not turn o,
check that the water tank is correctly in
place.
CLEANING & STORAGE
―
WARNING: ALWAYS TURN THE
APPLIANCE OFF AND UNPLUG
THE POWER CORD FROM THE
ELECTRICAL OUTLET BEFORE
HANDLING OR CLEANING IT.
CAUTION: DO NOT ALLOW WATER
OR OTHER LIQUIDS TO RUN INTO
THE INTERIOR OF THE APPLIANCE,
AS THIS COULD CREATE A FIRE AND/
OR ELECTRICAL HAZARD.
To Next Page
Loading...
Need help?
General
