Probuilder 16937 - Assembling the Vacuum Cleaner; Vacuuming: Dry; Vacuuming: Wet

27
GB
1. Assembling the vacuum cleaner
Check that there is no power being supplied
to the vacuum cleaner.
Open the clasps (fi g. 1a).
Lift the upper section of the vacuum cleaner
off (fi g. 1b).
Take out all the small parts and check that all
the parts are there (see list above).
Place the steel tank on the holder with
wheels (fi g. 1c).
For dry vacuuming: Insert the dust fi lter (fi g.
1d).
For wet vacuuming: Insert the foam fi lter (fi g.
1e).
Place the upper section of the vacuum
cleaner back in position (fi g. 1f ). Check that it
is securely in place – close the clasps (fi g. 1g).
Connect the hose to the suction hose
connection (fi g. 1h) (turn it gently until it
clicks into place).
Attach the desired nozzle, depending on
what you intend to vacuum (fi g. 1i/fi g. 1j).
Use
2. Vacuuming: dry
Check that there is no power being supplied
to the vacuum cleaner.
Lift the upper section of the vacuum cleaner
off (fi g. 2a) and place the dust fi lter in the
tank (fi g. 2b).
Put the upper section back on.
Connect the hose to the suction hose
connection (fi g. 2c) and screw it tight
(clockwise). Attach the required nozzle to the
telescopic tube.
Plug in.
Switch the vacuum cleaner on (I) (fi g. 2d).
Once you have fi nished using the vacuum
cleaner, switch it off (0) and remove the plug
from the wall socket.
NEVER USE THE DUST FILTER FOR WET
VACUUMING
0 = off I = on
3. Vacuuming: wet
Check that there is no power being supplied
to the vacuum cleaner.
Check that the tank is clean/empty.
Lift the upper section of the vacuum cleaner
off (fi g. 3a) and insert the foam fi lter (fi g. 3b).
Make sure that the fi lter covers the entire
fi lter basket before you start vacuuming (fi g.
3c).
Put the upper section back on.
Connect the hose to the suction hose
connection (fi g. 3d) and screw it tight
(clockwise). Attach the required nozzle to the
hose.
Plug in.
Switch the vacuum cleaner on (I) (fi g. 3e).
Once you have fi nished using the vacuum
cleaner, switch it off (0), remove the plug
from the wall socket and empty the tank.
NEVER USE THE DUST FILTER FOR WET
VACUUMING
0 = off I = on
IMPORTANT:
The vacuum cleaner is equipped with a valve
that ensures that the suction power ceases
and the motor starts making more noise
once the tank is full. If this happens, switch
off the appliance immediately, unplug it
and empty the tank, as the motor may be
damaged otherwise.
If the vacuum cleaner tips over, turn it off ,
stand it upright again and switch it back on.