Procopi REGUL SYSTEM User Manual

Automatic dosing
and regulation system
REGUL SYSTEM
INSTRUCTIONS FOR INST
ALLATION AND USE
Thank you for buying a REGUL SYSTEM automatic dosing and regulation station. This is an efficient, powerful and reliable
product. Prior to installation and utilisation, the subsequent information must be read carefully. It contains important
recommendations as to handling and utilisation. Make sure not to lose this information and hand it to any potential user.

Procopi REGUL SYSTEM Specifications

General

Brand	Procopi
Model	REGUL SYSTEM
Category	Swimming Pool Filter
Language	English

Summary

General Information

Foreword

Introduction to the REGUL SYSTEM dosing and regulation station for private pools.

Reading Scale

Details pH range (0-14) and Redox mV range (0-1999mV) with precision.

Entry Signals

Describes two analogue entries for pH/Redox control and empty tank alarms.

Installation Guide

Putting Into Operation

Instructions for mounting the assembly plate in a dry, ventilated place away from products.

Electrical Connections

Electrical installation must follow regulations, connect to 220V ±10% power supply.

Circulation Tank Connection

How to connect the circulation tank with filter and sensor holder to the filtration system.

Injector Installation

Instructions for installing injectors before water entry into the pool, spaced 50 cm apart.

Suction Laterals

Connecting tank alarm sensor, aspiration tube, and injection tube to the doser head and tank.

Circulation Tank Connection Diagrams

Diagrams illustrating different methods for connecting the circulation tank.

Installation Diagram

Schematic overview of the complete installation setup for the REGUL SYSTEM.

Operation and Calibration

Sensors

Warning about sensor deterioration and how to install them correctly.

Display Overview

Explains the main menu display showing water parameters and injection percentages.

Password Protection

Details access to the SETUP menu protected by a four-digit password.

Keyboard Functions

Describes the keyboard layout and functions, including power ON/OFF.

Special Functions

Explains ON/OFF, REINITIALIZATION, and START functions of the dosing station.

Sensor Calibration Procedure

Steps for calibrating pH and Redox sensors using buffered solutions.

System Setup and Configuration

Start-up Delay and Password

Setting up the start-up delay for pumps and changing the system password.

Redox Cut-in Value Determination

Procedure to determine the Redox cut-in value for chlorine dosing.

pH Cut-in Value Programming

Programming cut-in values for pH, including proportional and ON/OFF modes.

Redox Cut-in Value Programming

Programming cut-in values for Redox (mV), including proportional and ON/OFF modes.

ON/OFF Mode Option

Option to program ON/OFF mode instead of percentage values for dosing.

Recommendations and Maintenance

Important Recommendations

Guidelines on tube usage, operating temperature, and earthing the pool water.

Cleaning pH and Redox Electrodes

Instructions for cleaning pH and Redox electrodes from deposits and films.

Storage of Electrodes

Guidelines for storing pH and Redox electrodes properly to maintain responsiveness.

Troubleshooting

Troubleshooting Guide

A guide to diagnose and solve common issues with the dosing station.