1. Unplug cord from electrical outlet.
2. Remove complete cutting assembly as
shown. Push piercing lever up and to the
left. It will pop out of a locked position.
3. Wash cutting assembly in hot, soapy
water. Rinse and dry thoroughly.
4. Wipe body of can opener with damp
cloth. NEVER immerse the can opener in
water.
5. To reassemble, place knob on back of
cutting assembly into large end of key-
hole as shown. Push to the right until it
snaps into place.
Cleaning Your Can Opener
1. This feature is on selected models.
2. Place cutting edge of knife in knife slot
located on back of can opener.
3. Draw knife blade through slot several
times.
NOTICE: To prevent damage to the can
opener and knives, do not insert serrated
blades into this unit.
Sharpening Knives
5
To Next Page
Loading...
