28
System Installation
19
Find the air kit for the nozzles and
disconnect the 5/32in black air
tubing from both sides of the tee.
22
Fill all voids around the 1/2in black
tubing in the pan with silicone to
avoid leaks.
18
Find the water kit for the nozzles and
disconnect the 5/32in clear water
tubing from both sides of the tee.
21
Strap each 1/2in black tubing line in
place, ensuring that it starts at the block
and ends 2-3in into the bottom area of
the case.
17
Secure the drain line.
20
Run one section of the 5/32in clear
tubing and one section of the 5//32in
black tubing through the 1/2in black
tubing at each end of the case. If needed, use
soapy water as a lubricant to run the lines through.
To Next Page
Loading...