3. POSITIONING THE STAND
1. Place the stand in the vertical position.
2. Ensure that the ground is strong enough to prevent any sinking of the stand into the ground. The
stability of the stand is of prime importance for a secure operation.
3. Pull out the spring pin (E), and flip the legs (A) from vertical position to horizontal position. If precisely
desired legs angle is not available please turn the leg-brace screw jack (H).
4. Choose the proper hole in the leg (A) and restore the spring pin (E).
5. Use the leg-brace screw jacks (H) to ensure the feet (I) touch the ground.
6. Continue the leg-brace screw jacks (H) of each leg in sequence until the base plate slightly lift off the
ground.
7. When the stand in securely positioned and vertical, check again that the leg-brace sliders(G) are
properly locked into their holes on the legs. The stability of the stand is of prime importance for a secure
operation.
10
To Next Page
Loading...