EasyManua.ls Logo

Proficook PC-EKI 1034 - Storage and Troubleshooting; Housing and Surface Cleaning; Troubleshooting Common Issues

Proficook PC-EKI 1034
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
53
WARNING:
Under no circumstances should you immerse
the device in water for cleaning purposes.
Otherwise this might result in an electric shock
or re.
CAUTION:
Do not use a wire brush or any abrasive items
.
Do not use any acidic or abrasive detergents.
CERAN
®
-Glass ceramic Hob
Clean the surface from food remains when it‘s
still warm using a moist cloth or tissue.
Wash the hob using a soft sponge and some
water, then wipe dry with a soft cloth.
Cleaning agent for glass-ceramics surfaces:
In case of stubborn, baked-in remains, use
suitable cleaning products available at special
departments of department stores.
Housing
Clean the housing after use using a slightly
moist cloth.
Make sure that no uid matter gets into any of
the openings of the housing. This might dam-
age the device or result in an electric shock.
Storage
Only store the appliance clean and after it has
cooled down.
During longer periods of non-use we recom-
mend storing the appliance in its original
packaging.
Always store the appliance in a well-ventilated
and dry place out of reach of children.
CAUTION: Risk of breakage!
Please remember that the CERAN
®
surface can
be damaged by heavy or falling objects.
Troubleshooting
Device does not function, no indication on
the display.
Remedy:
Check the mains connection.
Several warnings will sound after the ap-
pliance has been turned on and after the
cooking function has been selected
Possible cause:
No cookware or unsuitable cookware was
placed onto the plate.
NOTE:
For safety reasons, the appliance will switch to
standby mode after about 15 seconds.
Remedy:
Put a pot on the hob that is suitable for induc-
tion hobs.
The hob suddenly switches off during
operation.
Possible cause:
The thermal cut-off is activated.
Remedy:
Disconnect the appliance from mains power
supply and let it cool down for approx. 20 min-
utes. Then start operating the device again.
Further cause:
The ventilation slots are obstructed.
Remedy:
Free the ventilation slots from any obstructions.
Further cause:
The hot plate was automatically switched off
after 120 minutes.

Table of Contents

Related product manuals