Appendix 2
Over-Encapsulating Caplets into Capsules
4. Pour caplets onto Caplet Tray and tilt in all
directions moving caplets into slots.
5. Tilt Caplet Tray to pour off excess caplets. 6. Place Caplet Tray on Caplet Orienter Base
and slide back until it drops into place.
7. Push sliding portion of Caplet Tray to the left
to drop the caplets into the capsules.
8. For all sizes, move the Caplet Orienter Base
with Caplet Tray to position II on OE Guide Tray.
Repeat steps 4-7.
For sizes A, B, and D only, a third cycle is
required. Move the Caplet Orienter Base with
Caplet Tray to position III on OE Guide Tray.
Repeat steps 4-7.
9. Remove the Caplet Orienter Base, Caplet Tray
and OE Guide Tray. Continue with Operating
Instructions in your ProFiller 3700/3800 Manual.
Begin with “Filling Capsules” if adding an
excipient (page 18 in Manual v 1.2.1), or
continue with “Locking Capsules” to lock the
outer capsules (page 20 in v 1.2.1).
To Next Page
Loading...