Profitec Pro M54 - REGULATORY COMPLIANCE; CE Conformity Standards; DISPOSAL INFORMATION; MAINTENANCE AND REPAIRS

Bedienungsanleitung / Instruction manual ProM54 16
Problem
Possible Cause
Troubleshooting
The grinder motor is working, but
no ground coffee is falling out of
the spout.
The lock slide of the bean hopper
is closed.
Open the lock slide of the bean
hopper.
The coffee shaft is blocked with
coffee powder.
see instructions above.
The grinder motor produces a
humming sound, does not
operate, does not grind any
beans.
The grind is too fine: The grinding
burrs touch and mutually block
each other.
Adjust the grind to a coarser
degree.
The coffee shaft is blocked with
coffee powder. The coffee is
blocking the motor.
Clean the coffee shaft, adjust the
grind to a coarser degree.
Grind cannot be adjusted.
Thread is blocked with coffee.
Clean the thread.
Sparse coffee dispensing from
the espresso machine,
only drop by drop
The grind is too fine
Adjust the grind to a coarser
degree.
There is too much ground coffee.
Use less ground coffee.
Æ Reduce grinding time.
Too much tamping pressure
Use less pressure when tamping.
Little or no crema on top of the
coffee
The grind is not fine enough.
Adjust the grind to a finer degree.
User more pressure when
tamping.
The coffee is old.
Use fresh coffee.
The shower screen is dirty.
Clean the shower screen.
Ambient and humidity conditions
have changed.
Adjust the grind accordingly.
Foam instead of crema
The coffee beans are improper
Use another coffee bean.
The setting of the coffee grinder is
not suited for the coffee mixture in
use
Adjust the coffee grinder (When
changing the coffee beans,
changing
the grind may also be necessary.)
8 CE CONFORMITY
Conformity
This product complies with the following directives / standards:
IEC 60335-1(ed5) +A1 +A2
IEC 60335-2-64:2002 +A1 +A2
EN 60335-1:2012 +A11 +A12 +A13
EN 60335-2-64:2000 +A1
EN 62233:2008
EN 55014-1:2006 +A1 +A2
EN 55014-2:1997 + A1 +A2
EN 61000-3-2:2014
EN 61000-3-3:2013
9 DISPOSAL
WEEE Reg. No.: DE97592029
This product complies with EU Directive 2012/19/EU and is registered according to WEEE (Waste Electrical
and Electronic Equipment).
10 MAINTENANCE
Any repairs or changes of components must be carried out by an authorised specialty dealer.
If your burrs have to be replaced (usually after grinding 250 kg of coffee), please contact your authorised
specialty dealer.