32
STRAIGHT (90°) CUTS
For 90° cuts, place the material in a 90° angle to the cutting guide.
1. Use a pencil or marker pen to draw
the cutting line.
2. Remove the angle guide.
3. Position the cutting guide at the
desired distance from the cutting
disc and secure it in place.
4. Place the material on the table.
5. Before switching the machine on,
ensure that the material is not
touching the disc.
6. Switch the machine on.
7. Wait until the disc has reached its
full rotational speed and is wet
before starting to cut.
8. Hold the material close to the
cutting aid and guide it towards
the cutting disk.
9. Once the cutting has been completed, switch o the machine and wait until the
cutting disc is no longer turning before removing the material.
To Next Page