32 33
45° DIAGONAL CUTS
45° cuts and cuts from one corner to another.
1. Use a pencil or marker pen to draw the cutting line.
2. Attach the angle guide.
3. Adjust the angle guide to 45° with
the help of an angle scale.
4. Position the cutting guide at the
desired distance from the cutting disc
and secure it in place.
5. Place the material on the table.
6. Before switching the machine on, en-
sure that the material is not touching
the disc.
7. Switch the machine on.
8. Wait until the disc has reached its full
rotational speed and is wet before
starting to cut.
9. Hold the material close to the cutting
aid and guide it towards the cutting disk.
10. Once the cutting procedure has been completed, switch o the machine and wait
until the cutting disc is no longer turning before removing the material.
To Next Page