Why ProFlight MAVERICK AIR PFBD200 lights are flashing but it does not respond to the control?
If the lights on your ProFlight Drone are flashing but it's not responding, it could be due to two reasons. First, the aircraft and transmitter might not be connected; in this case, repeat the connection procedure. Second, there might be insufficient battery power; if so, recharge the battery.
What to do if ProFlight Drones won’t fly using the App?
If your ProFlight Drone won't fly using the app, it could be due to a few reasons. The aircraft might not be connected to the app, so reconnect it following the instructions. Another reason might be that the connection was not done in the correct order, so reconnect following the instructions. Lastly, the main controller could be turned on. If this is the case, turn off the controller, and reset the aircraft, app, and Wi-Fi to reconnect to the app.
What to do if the camera is not working in ProFlight MAVERICK AIR PFBD200 Drones App?
If the camera isn't working in the ProFlight Drones App, it might be because the aircraft isn't connected to the App. To resolve this, reconnect using the instructions.
Diagram illustrating the various buttons and joysticks on the controller for operation.
Instructions on how to fold the front and rear arms of the drone correctly to avoid damage.
Press the blade guards into position and fix them securely with a screw.
Recover drone trim to original factory settings by holding joysticks in specific corners.
Fly in Headless mode where aircraft orientation matches pilot's orientation for easier control.
Adjust drone speed settings (30%, 60%, 100%) indicated by controller beeps.
Return the aircraft in a fixed direction by pressing the return button.
Perform 3D rolls left or right by pressing the 3D roll button and lever.
To Next Page
General