ELECTRONIC CONTROL PANEL
EN - English Page 12
MANUAL REGENERATION
It is possible to manually initiate a regeneration.
1. Press the scroll
button repeatedly until the display
shows:
If the control valve is left in this position, the count-
down timer will count down to 0 sec and start a
regeneration.
To cancel this mode, press the scroll
button
before the countdown timer has reached 0 sec; the
control valve will return to the service mode.
2. Press the scroll
button again if you want to manually
advance the control valve to the next regeneration cycle.
DRIVE MOTOR SPEED
The drive motor of the control valve, that drives the valve
body to its different regeneration positions, will start-up at
low speed to reduce its noise level. To increase the speed of
the drive motor, simply press the scroll
button as soon as
the drive motor is activated.
PROGRAMMING INSTRUCTIONS -
INSTALLER
!!! DOES NOT APPLY TO DUPLEX ECO ALTERNATING !!!
Before entering the programming mode, make sure
that the control valve is in the service mode.
1. Press the scroll
button; the display will show:
Press the up
or down
button to set the
language.
2. Press the scroll
button again; the display will show:
Press the up
button or down
button to set the
time of day.
3. Press the scroll
button again; the display will show:
Simplex Tempo:
Press the up
or down
button to set the number
of days between regenerations.
Simplex Eco, Duplex/Triplex Eco Parallel:
Press the up
or down
button to set the
hardness of the incoming untreated water.
To Next Page
Loading...