ELECTRONIC CONTROL PANEL
Page 13 EN - English
PROGRAMMING INSTRUCTIONS -
PARAMETER SET LEVEL
Before entering the programming mode, make sure
that the control valve is in the service mode.
All configuration parameters on this water softener
have been pre-programmed in the factory, to offer optimal
performance in a wide range of applications and situations.
Nevertheless it may be necessary or desirable to change
any of these parameters, to further optimize the water
softeners performance or to adapt it to the specific
requirements of the installation.
SIMPLEX TEMPO:
1. Press the scroll
button and hold it for 5 sec until the
display shows:
2. Within 10 sec, press the up
button; the display will
show:
Press the up
or down
button to set the length
of the regeneration cycle.
Press the scroll
button again to advance to the
next regeneration cycle.
3. Press the scroll
button again; the display will show:
Press the up
or down
button to set the time of
regeneration.
4. Press the scroll
button again; the display will show:
Press the up
or down
button to save the
program into the NOVRAM® and exit the
programming level.
To Next Page
Loading...