ELECTRONIC CONTROL PANEL
Page 15 EN - English
DUPLEX ECO ALTERNATING:
Each of the 2 Simplex system must be programmed
individually; the program does NOT necessarily have to be
the same on both Simplex systems, that make up a Duplex
system!
1. Press the down
button and hold it for 5 sec until the
display shows:
2. Within 10 sec, press the buttons in the following
sequence: down
- down
- scroll
- down
; the
display will show:
Press the up
or down
button to set the volume
of softened water between regenerations, for the
Master system; this must be calculated, by dividing
the nominal exchange capacity of the system (see
Technical Data) by the water hardness.
3. Press the scroll
button again; the display will show:
Press the up
or down
button to set the volume
of softened water between regenerations, for the
Slave system; this must be calculated, by dividing the
nominal exchange capacity of the system (see
Technical Data) by the water hardness.
4. Press the scroll
button again; the display will show:
!!! Please disregard this function !!!
5. Press the scroll
button again; the display will show:
Press the up
or down
button to set the number
of days between regenerations, for the Master
system.
6. Press the scroll
button again; the display will show:
Press the up
or down
button to set the number
of days between regenerations, for the Slave system.
7. Press the scroll
button again; the display will show:
Press the up
or down
button to set the length
of the regeneration cycle, for the Master system.
Press the scroll
button again to advance to the
next regeneration cycle.
9. Press the scroll
button again; the display will show:
Press the up
or down
button to set the type of
water meter sensor.
10. Press the scroll
button again; the display will show:
Press the up
or down
button to save the
program into the NOVRAM® and exit the
programming level.
To Next Page
Loading...