To Next Page

To Previous Page

5. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON

a. Use only a CUL-listed surge protector, rated at 15 amps, with a 14-gauge cord of 1,5 m (5 ft) or less in length.

b. If the walking belt is overtightened, treadmill performance may

decrease and the walking belt may be permanently damaged.

Remove the key and UNPLUG THE POWER CORD. Using the

allen wrench, turn both rear roller adjustment bolts counterclock-

wise, 1/4 of a turn. When the walking belt is properly tightened,

you should be able to lift each side of the walking belt 5-7 cm (2

to 3 inches) off the walking platform. The center of the walking

belt should just touch the walking platform. Be careful to keep

the walking belt centered. Plug in the power cord, insert the key

and run the treadmill for a few minutes. Repeat until the walking

belt is properly tightened.

c. If the walking belt still slows when walked on, please call our toll-free Customer Hot Line.

6. SYMPTOM: THE WALKING BELT IS OFF-CENTER

a. If the walking belt has shifted to the left, first remove the key

and UNPLUG THE POWER CORD. Using the allen wrench,

turn the left rear roller adjustment bolt clockwise, and the right

bolt counterclockwise, 1/4 of a turn each. Be careful not to over-

tighten the walking belt. Plug in the power cord, insert the key

and run the treadmill for a few minutes. Repeat until the walking

belt is centered.

b. If the walking belt has shifted to the right, first remove the

key and UNPLUG THE POWER CORD. Using the allen wrench,

turn the left rear roller adjustment bolt counterclockwise, and the

right bolt clockwise, 1/4 of a turn each. Be careful not to over-

tighten the walking belt. Plug in the power cord, insert the key

and run the treadmill for a few minutes. Repeat until the walking

belt is centered.

c. If the walking belt slips when walked on, first remove the key

and UNPLUG THE POWER CORD. Using the allen wrench,

turn both rear roller adjustment bolts clockwise, 1/4 of a turn.

When the walking belt is correctly tightened, you should be able

to lift each side of the walking belt 2 to 3 inches (5–7 cm) off the

walking platform. Be careful to keep the walking belt centered.

Plug in the power cord, insert the key and run the treadmill for a

few minutes. Repeat until the walking belt is properly tightened.

Rear Roller Adjustment Bolts

5–7 cm

ProForm PCTL74100 User Manual

Other manuals for ProForm PCTL74100