Need help?Do you have a question about the Profoto OCF Zoom Reflector and is the answer not in the manual?
General| Brand | Profoto |
|---|---|
| Model | OCF Zoom Reflector |
| Category | Camera Accessories |
| Language | English |
Open the clasp on the rubber collar and gently push the reflector onto your light.
Before closing the clasp, adjust the light spread by sliding the reflector back and forth on the head.
Pull back the reflector for a wide light spread.
Push the reflector forward to gradually narrow the light spread and increase the light output.
Lock the reflector to your selected position by closing the clasp on the rubber collar.
Mount the reflector, pull it back as much as possible, and put on the transport cap.
Turn the stand mount to a horizontal position.
Pack the prepared light and reflector into your bag.
Mount the reflector onto the B2 head, pull it back, add cap, and turn stand mount horizontal.
Wind the cable around the reflector. Wait until the reflector has cooled off.
Pack the prepared B2 head and reflector into your bag.
To Next Page
