2. Gasoline engine, air cooled
Open the fuel valve.
Set the ON/OFF button to the ON position.
Turn the key to start the engine (please let the engine run idle for 5 minutes before use).
Make sure the choke lever is closed when starting in normal cold working state.
Stopping the engine
To stop the equipment, depress the clutch lever. Or if there is a brake system on the equipment, stop the
equipment by braking, depress the clutch lever, then switch the engine off. Make sure the equipment is not
set in a gear and the clutch is disengaged before switching the engine off.
To stop the gasoline engine you need to use the starting key, while stopping the diesel engine is done by
reducing the accelerator level until the engin stops (decompression).
Operation instruction for Synchronized 4x4 system
A. Main reduction gearbox
B. Front transmission gearbox
C. Middle speed reduction gearbox
D. Rear transmission gearbox
a. gearshift for main reduction gearbox
b. actuation lever for front accesories
c. forward gears handle for front transmission gearbox
d. reverse gear handle for front transmission gearbox
e. gearshift handle for middle speed reduction gearbox
f. electronic operation handle for hydraulic system
g. forward gears handle for rear transmission gearbox
h. reverse gear handle for rear transmission gearbox
i. gearshift handle for back rotary tiller
General introduction
The PROGARDEN 4x4 mini tractors are divided into two types by power source:
a) mini tractors with gasoline engine
b) mini tractors with diesel engine
A. Main reduction gearbox: Changes speed of both gearboxes and the rear PTO. It has 3 settings: Low /
Neutral / High. Set the control lever forward to Low position, middle for Neutral position and backward for
Ver. 1/Rev. 2; Data: 18.09.2023
26
To Next Page
Loading...