24
If you have any questions regarding the product, please call customer service at 1-866-389-8827.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Motor not running. 1. No power. 1. Check cable, plug, socket, and fuse.
Motor runs, cutting
disk remains still.
1. Arbor nut loose. 1. Check the inner washer and outer
washer are seated correctly and then
tighten the arbor nut if necessary.
It is difficult to cut
materials.
1. Tile cutting wheel is dull. 1. Replace the cutting wheel.
Cutting wheel runs
irregularly/vibrates.
1. Cutting wheel warped.
2. Cutting wheel fitted incorrectly.
1. Replace the cutting wheel.
2. Fit the cutting wheel correctly.
Cutting wheel is
discolored.
1. Insufficient cooling water.
2. Lateral friction caused by runout.
1. Fill the basin with sufficient water.
2. Guide workpiece through cutting wheel
more slowly.
To Next Page
Loading...