What to do if my Project Source Saw cutting wheel is discolored?
If the cutting wheel of your Project Source Saw is discolored, it could be due to insufficient cooling water or lateral friction. First, fill the basin with sufficient water. If the issue persists, guide the workpiece through the cutting wheel more slowly.
Why is my Project Source Saw motor not running?
If the motor of your Project Source Saw isn't running, the cause may be no power. Check the cable, plug, socket, and fuse.
What to do if my Project Source PSWS-B7-20 Saw cutting wheel runs irregularly or vibrates?
If the cutting wheel on your Project Source Saw runs irregularly or vibrates, it could be due to a warped cutting wheel or incorrect fitting. Consider these steps: * Replace the cutting wheel. * Fit the cutting wheel correctly.
Why does the cutting disk of my Project Source PSWS-B7-20 remain still when the motor runs?
If the motor of your Project Source Saw runs but the cutting disk remains still, the arbor nut might be loose. Check that the inner washer and outer washer are seated correctly, and then tighten the arbor nut if necessary.
How to fix difficult material cutting with my Project Source PSWS-B7-20 Saw?
If it is difficult to cut materials with your Project Source Saw, the tile cutting wheel may be dull. Replace the cutting wheel.
Precautions for personal safety and preventing equipment damage.
Instructions to follow before operating the product for the first time.
Guidelines for safe operation and maintaining a safe work environment.
Instructions for carefully unpacking the product and inspecting for damage.
Information and recommendations regarding the use of the cutting wheel.
Step-by-step guidance on installing critical cutting components.
Procedure for attaching the blade guard for safety.
Steps to install and adjust the rip guide for straight cuts.
Instructions for attaching and adjusting the miter guide for angled cuts.
Procedure for fitting the overflow drain into the water reservoir.
Description of the intended uses and types of cuts for the tile saw.
Explanation of the saw's switch, including its locking feature.
Instructions on how to secure the saw using the safety key.
Steps for filling the water reservoir for cooling during operation.
Procedure for safely draining and refilling the water reservoir.
Guide on how to attach and use the extension table for larger tiles.
Details on positioning and using the rip guide for cuts.
Instructions for adjusting and using the miter guide for angled cuts.
General advice and precautions for performing various types of cuts.
Step-by-step guide for making straight 90-degree cuts.
Instructions for performing 45-degree diagonal cuts.
Procedure for making miter cuts at angles other than 90 degrees.
Method for making L-cuts to fit pieces around corners or obstacles.
Instructions for making beveled cuts at 22.5 and 45 degrees.
Information regarding the tool's lubrication and maintenance schedule.
Steps for cleaning the miter guides to ensure smooth operation.
Procedure for cleaning the main components of the tile saw.
General| Brand | Project Source |
|---|---|
| Model | PSWS-B7-20 |
| Category | Saw |
| Language | English |
To Next Page