Projecta IS1220 User Manual

8
Note: In general, with the use of Rapid Recharge Technology (RRT) the Jumpstarter does
not require charging. However, while not in use it is recommended to check the
Jumpstarter’s charge status via the BATTERY STATUS INDICATOR. If required, charge
the Jumpstarter using the supplied 12V USB charger or a 3rd party 10W 240VAC USB
adaptor (not provided). This will ensure the Jumpstarter is ready when required.
UNDERSTANDING YOUR JUMPSTARTER
CLAMP CONNECTION LED
Jumpstart Status LED
Jumpstarter clamps connected to vehicle and ready to jumpstart Green solid
Jumpstarting for more than 5 seconds Yellow flash twice, pause & repeat
Battery or Jumpstarter switch, over-temperature Red / Green alternate flashing
Battery charging temperatures >45°C or <0°C Red / Green alternate flashing & siren
Short circuit Red flashing & beeping siren
Clamps reverse connected to battery Red solid & siren on
Jumpstarter input voltage (EC5 connector) > 15.0V Red / Yellow alternate flashing & siren on
Low voltage indication Red flashing, no beeping siren
Hardware failure Red fast flash, steady siren on
BATTERY STATUS INDICATOR
When Jumpstarter is turned on the battery gauge LED’s are displayed as follows:
State of Charge Battery Gauge LED Display
<20%
– Red flashing
20–25%
– Red
25–50%
– Yellow
50–75%
– Green
75–100%
– Green
When Jumpstarter is charging the battery gauge LED’s are displayed as follows:
State of Charge Battery Gauge LED Display
<20%
– Scrolling
20–50%
– Red with Yellow & Green scrolling
50–75%
– Yellow with Green scrolling
75–99%
– Green with Green flashing
100%
– All solid Green

Projecta IS1220 Specifications

General

Brand	Projecta
Model	IS1220
Category	Remote Starter
Language	English