EasyManuals Logo

Projecta LS950 User Manual

Projecta LS950
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
7
DC CHARGING, while driving.
1. Plug the DC adaptor into the jumpstarter’s charging port.
2. Connect the Cigarette plug to the vehicles Cigarette power socket, and start the car. The LCD
will now display CHARGING.
3. When the battery is charged the LCD display will show FULLY CHARGED and the jumpstarter
will stop charging.
4. Disconnect the Cigarette plug to the vehicles Cigarette power socket and unplug the charger
from the Jumpstarter.
WHEN TO CHARGE
Your Jumpstarter is shipped partially charged. Therefore you should charge the Jumpstarter
before using it for the first time. It is recommended to charge fully after each use so the
Jumpstarter is ready in case it is required.
POWER BANK
The Jumpstarter has a USB output with 2.1A and 1.0A out. It is suitable to charge phones,
tablets, cameras and GPS devices. The Jumpstarter will turn off after 2 minutes of no activity
or the USB device has been fully charged.
If the USB output becomes overloaded, remove the device and check it. Turn the Jumpstarter
off and back on again, the USB output should work again.
WARNING: Charging devices from the Jumpstarter will drain the battery and potentially
cause the Jumpstarter to fail to start your vehicle in an emergency. Recharge the Jumpstarter
as soon as possible.
FLOOD LIGHT
The Flood light has 3 functions. These are:
1st press - Flood light mode
2nd press – Strobe mode
3rd press – SOS mode

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Projecta LS950 and is the answer not in the manual?

Projecta LS950 Specifications

General IconGeneral
BrandProjecta
ModelLS950
CategoryRemote Starter
LanguageEnglish

Related product manuals