Montageanleitung / Installation manual
MBN GmbH, Balthasar-Schaller-Str. 3, 86316 Friedberg - Germany
www.proled.com
Cut the funnel diagonally. Fill the end cap completely with the glue.
Move the end cap over the strip, so that the soldering
pads are covered.
Caution:
Please leave new glued end cap minimum 24 h without movement for drying. Please be advised, that silicone is not a
maintenance-free. The glue must be checked regularly, but at least once a year, and must be replaced if needed.
To Next Page
Loading...