PL-2303 Mac OS X Driver Installation Guide
Document Rev 1.4
PL2303 Mac OS X 10.6 and Above Driver Installation Guide.doc
Prolific Technology Inc. - 3 of 10 - January 16, 2015
All information herein is subject to change without prior notice. Prolific Technology Inc. does not make any warranties regarding
the accuracy and completeness of this document and shall in no event be liable for any loss of profit or any other commercial
damage, including but not limited to special, incidental, consequential, or other damages.
3. At the end of the installation, you will need to restart your computer. Close all programs and click
Restart to complete installation and reboot the system.
4. After rebooting the system, you can now plug the PL-2303 USB-to-Serial adaptor or cable to the
USB port. You can first run the System Profiler program under the Applications-Utilities folder.
Click USB hardware inside System Profiler and look for “USB-Serial Controller” or “USB-Serial
Controller D”. This means that the hardware device is detected by your Mac computer.
To Next Page
Loading...