10
Adding the rinse aid
Rotate the dispenser cap anticlockwise and remove it.
Add the rinse aid until the container is full (approximately 110ml). The optical level
indicator on the side of the cap should be completely obscured.
Replace the cap and turn it clockwise.
NOTE: Refill the rinse aid when the optical level indicator becomes clear again, or when the
rinse aid warning light comes on.
Adjusting the rinse aid dispenser setting
The factory setting for the dishwasher is 4 and there are 6 settings for your choice.
The amount of rinse aid dispensed is proportional to the selector position.
1. To adjust the rinse aid setting, rotate the dispenser cap
anticlockwise and remove it.
2. Use a screwdriver to rotate the rinse aid selector to the
desired position.
3. Replace the cap by turning it clockwise.
NOTE: The amount of rinse aid must be increased if the washed dishes appear dull or feature
circular stains. If the dishes are sticky or have white streaks, it is necessary to reduce the
rinse aid setting.
To Next Page
Loading...
Need help?
General
