Tips for drying wet cloths
Allow a 30
-50 cm gap between the air outlet and any clothing.
To allow good airflow, line the wet clothes up and leave space between each garment.
Hang wet thick clothing directly in front of the air outlet. The optimal drying performance may not be
obtained for thick and heavy clothing.
Smart dehumidifying mode
GB6
Repeatedly press until the indicator light illuminates, indicating that the appliance is in the
smart dehumidifying mode.
In this mode, the appliance will automatically control room humidity in a comfortable range 45% ~ 55%.
NOTE: You cannot set the humidity level when the appliance is in this mode.
Ioniser
Press to activate the ioniser function whilst the indicaotor light will illumiante.
The appliance will release negative ions from the air outlet.
To deactivate this function, press again. The indicator light will go out.
Turbo Fan Speed
Press to activate the turbo fan speed whilst the indicator light will illuminate.
When the humidity has been reduced and quiet operation is preferred, set the fan speed to a normal
setting by pressing this button again. The indicator light will go out.
Timer
To programme the delayed start function:
1. When the appliance is in the power off state,
press
.
The indicator light will illuminate and the display will show the hour.
2. While the hour is displaying, repeatedly press or press&hold / to set the desired hours.
The delayed start time will be changed by 0.5 hour increments up to 10 hours, and then by 1 hour
increments up to 24 hours.
3. After a few seconds the set time will be confirmed and then disappear from the display.
4. When the set time has elapsed, the appliance will start working.
Downloaded from www.vandenborre.be
To Next Page
Loading...
Need help?
General
