To programme the delayed stop function:
1. When the appliance is in the power on state, press .
The indicator light will illuminate and the display will show the hour..
2. While the hour is displaying, repeatedly press or press&hold / to set the desired hours.
The delayed stop time will be changed by 0.5-hour increments up to 10 hours, and then by 1-hour
increments up to 24 hours.
3. After a few seconds the set time will be confirmed and then the display will return to the ambient
GB7
humidity level.
4. When the set time has elapsed, the appliance will stop working.
To modify or cancel the timer:
If you wish to modify the set delayed start or stop time, press once and then while the hour is
displaying, repeatedly press or press&hold / until the desired time is selected.
If you wish to cancel the timer, press once and then while the hour is displaying repeatedly press
or press&hold / until “0.0” is selected. You can also press .
The timer will also be cancelled when the display shows the error code “P2”.
Other Functions
Bucket full
The indicator light will illuminate when the water bucket is full or not in place. Please empty the
bucket or replace it in the correct position and then this indicator light will go out.
Auto Shut Off
The dehumidifier will shut off when the water bucket is full, or when the water bucket is removed or not
placed in the proper position. It will also be shut off when the set dehumidty level is reached.
Auto Defrost
When frost builds up on the evaporator coils, the compressor will cycle off and the fan will continue to run
until the frost disappears.
When auto defrosting is operating, the dehumidifier may make some noise due to the flow of the
refrigerant. This is normal.
Downloaded from www.vandenborre.be
To Next Page
Loading...
Need help?
General
