Beta Draft Confidential
12 Proliphix Thermostat Installation Guide, Release 1.0
Part No. 600-01000-100
Installing and Wiring the Thermostat
Testing the Cool Controls
1 Press HVAC.
2 Press Mode. A menu list appears.
3 Use the Up and Down arrows on the right side of the panel to select Cool.
4 Press Select.
5 Press Back.
6 Continuously press the Down arrow until the cool set point is lower than the
temperature reading. The cool and fan relays should click and the HVAC system
should activate the cool and fan.
Testing the Fan Operation
1 Press HVAC.
2 Press Fan. A menu list appears.
3 Use the Up and Down arrows on the right side of the panel to select On.
4 Press Select. The fan relay should click and the fan should turn on.
To Next Page
