General guidelines for using the CTX:
Fill up the water bowl with cold water until it almost covers the top of the central post inside the water bowl (fig
1) The motor unit is then placed on top of the water bowl (fig 2). The suction port of the bowl should be lined
up with the notch in the motor unit. The edge of the motor unit should firmly rest on the top of the water bowl
and be inside of the retaining ring for correct location, otherwise the machine will not work. This is because of
the safety switch located on the underside of the motor unit. Engage the two clamps, catch the lower latch piece
to the water bowl tabs and push the upper latch piece towards the motor unit locking the latches in place. Once
the water bowl has been latched to the motor unit place the machine on top of the wheeled base. Note: The
clamps will not operate properly if the motor unit is not in the proper position on the water container. If
the clamps do not operate easily, check the location of the motor unit.
Whichever hose you choose to use can now be connected to the water bowl port and locked into place. Just
insert the hose end into the port and twist to lock into place. You can now attach the wand(s) to the hose end
and then connect either the electric powerhead or any of the attachments to the wand end. Turn the vacuum on
with the power switch on top of the motor unit and you’re ready to clean.
WATER CONTAINER / HYDRO TURBINE
To Next Page
Loading...
