You can set the type 0(receive)/1(transmit) by this command
The WEC200 will reboot after you execute this command.
Default: 1(transmit)
6-O. Notice Message
Notice Message is Device to send a notice to host automatically.
When you set up auto advice by (=1), once the status of the two inputs differ from the previous status, a
string data will go automatically by STX—C—CR to give you the notice of input is changing due to 0.1(s)
has detected itself. It implied that several messages might send out already. After receipt of these
messages, apply 6-C command to get the current status of these two inputs.
Default: 0 (means no auto notice)
6-P. Auto get set up format when an variation is made
A backup message will run automatically when the input status varies.
X: 0—No backup/1—backup
6-Q. Notice Message
Notice Message is Device to send a notice to host automatically.
To Next Page
Loading...