Promag WEC200 - Wiegand Input; Relay - Contact and Input

4
pair)
3
RX+(Positive line of the differential input signal pair)
6
RX-(Negative line of the differential input signal pair)
4, 5 short connection & 7, 8 short connection
4-B. LED (indicator)
LED2 is a bi-color LED displaying two colors should be switched automatically by indicating
different status. (Please refer the details to Appendix A. LED2 Status)
LED3 (Red) displays the current connecting speed at100M. If 10M only which is fail.
LED1 (Green) normally displays the status of the Ethernet Port. When receiving an Internet
package, the LED1 will be cut off temporarily until the package is received entirely.
4-C. DC JACK
Pin#
Signal
Center (D2.1mm)
+12VDC
Outer
GROUND
4-D. Wiegand input
PIN#
1
2
3
4
5
Signal
+12V
+5V
GND
D0
D1
Mainly registered by PIN#CN2-L35005-T01-G
4-E. Relay - contact and input
Mainly registered by PIN#CN2-L35010-T01-G
Relay applies to:
“C” represents (Common) Contact
“N.C.” represents (Action) Contact
“N.O.” represents (Non action) Contact
Input
Relay#2
Relay#1
PIN#
1
2
3
4
5
6
7
8
9
10
Signal
+12V
GND
IN2
IN1
N.O.
C
N.C.
N.O.
C
N.C.