Promate 240 - Page 12

Run time is less than expected
Internal battery was not fully charged
Recharge using the AC charger, until
battery status read >12.8V
AC product power consumption is
Check AC product power or wattage
higher than expected
rating (or current draw for 12V DC
appliances)
Battery has been damaged
Note: Start up load will affect running
time of appliance
Jumpstart Problems
Problem
Possible Cause
Solution
The engine being boosted will not start
Powerstation battery is not fully
Recharge the battery.
charged
The engine condition is poor
Have the engine serviced.
The engine start capacity exceeds the
booster capability of the Powerstation
Charging Problems
Problem
Possible Cause
Solution
Charging Status light is off when AC
NO AC power at the AC wall outlet
Ensure power is available at the AC
charger is connected
wall outlet.
AC charger is faulty
Replace the AC charger
WARNING! ELECTRIC SHOCK HAZARD
Do not remove the housing or disassemble the Powerstation except to replace the internal battery. The Powerstation
does not contain any internal user-serviceable parts and attempting to service the unit yourself could result in
electrical shock or burn.
POWERTECH ASIA PACIFIC, INC.
Unit 2702-C West Tower PSE Centre
Exchange Rd. Ortigas Center, Pasig City
Philippines 1605
FOR SERVICE HOTLINE, CALL:
(02) 641 8800 / 628 1050