12V DC PORT
The Powerstation is equipped with an outlet socket and can be used to operate most 12-Volt auto accessories and appliances
(11 AMP maximum) equipped with a cigarette lighter plug. Simply plug in appliance. NOTE: Socket is live so appliance will be
instantaneously powered. Length of time appliance will operate depends on the condition of battery and current draw of
appliance. Periodically check battery voltage status “VDC” during operation and discontinue use immediately if battery
condition falls to 11V.
Recharge unit as soon as possible and before further use.
12V DC PORT is protected by an internal circuit breaker to prevent damage to unit in case appliance has a short circuit or
exceeds 11 AMPS. If circuit breaker is tripped, disconnect appliance and have it checked. Circuit breaker will automatically
reset once it cools down (approx. 15-20 minutes). DO NOT PLUG A CIGARETTE LIGHTER INTO THE OUTLET OF THE
POWERSTATION.
LED WORKLIGHT
1. Simply turn ON the LED work light by pressing the LIGHT button.
2. Turn OFF the LED work light by pressing again the LIGHT button
3. Turn OFF while not in use.
VI. JUMPSTARTING AN ENGINE
CAUTION
1. Make sure all switches of the Powerstation are in “OFF” position. Powerstation must be fully charged to jump-start
an engine. Do not attempt to jump-start an engine if the “VDC” reading of the Powerstation is < 12V when you press
the display button as this could permanently damage the battery.
2. Turn off ignition and all accessories (lights, radio, heater, air-conditioning, etc.) in the vehicle with weak battery
that will not start.
3. Place vehicle in park and set hand brake.
4. For maximum power, turn off all switches on your Powerstation and disconnect any accessories plugged into the
12 Volt power outlets.
5. Check that vehicle is negatively grounded (most vehicles).
6. Securely connect the External Battery Connection Cable red positive clamp to the positive (+) terminal of the vehicle
battery. Then, securely connect the black clamp to a grounding point on the vehicle such as the metal frame, as far
away from the battery as possible. DO NOT connect it to the negative battery terminal. Make sure both clamps have
good and correct polarity connection before connecting the other end of the External Battery Connection Terminal to
the Powerstation.
NOTE: Do not place Powerstation where it could fall when vehicle starts up. Make sure that cables are
routed away from motor fan or belts.
7. Start your vehicle.
8. Once vehicle starts, disconnect the external battery connection terminal from the Powerstation, black clamp, and
then red clamp in that order. Restore cables and recharge unit at first opportunity.
To Next Page
Loading...
