1. Connect Scope to a PC/Laptop/Mac or 5V USB adaptor (not included) with the
USB cable included
2. Red LED turns ON during charging and turns Green once the device is fully
charged.
3. When Scope is low on power a low battery pop up will appear on the screen.
Operation Instructions:
4
1. Charging Scope
1. Power on the Scope by long pressing the power switch.
2. Connect the Scope to your media source via HDMI/MHL cable and choose what
you would like to view from the menu on your device and play it as you normally
would.
3. You may project your media on any given surface. The projection will come up
automatically. However, for the best quality projection is best if you find a light
colored wall (preferably smooth and white) and place the Scope with its lens
facing the location. You can watch media up to 60’’, just move the projector
towards and away from the wall to adjust the size of the picture.
4. You may connect another external speaker using the 3.5mm audio jack provided.
Note: For 11-pin MHL devices (such as Samsung Galaxy S3/4/5; Note2 and etc.) you
need to use the 5-pin to 11-pin supplied MHL adapter and attach it to the MHL
cable.
For certain devices, an adapter is required to connect to the HDMI cable. Apple
devices require an Apple Digital AV Adapter (sold separately) for HDMI use.
2. Powering on and viewing media through Scope
1. Slide the Focus Slider on the Scope to fine-tune the output media
Adjusting the focus of the output media:
To Next Page
Loading...